B3KV-28-C ge gear unit sizes to Selection and ordering da Bevel-helical gear reducers B3

Flender/Flender Gear Units/Bevel-helical gear reducers B3

s of rotation. (The less frequently used parallel-crank couplings are an exception). Example: -ARPEX ARN-6 NEN 2-6 with shaft distance of 1mm with permitted radial misalignment of = 2.2 mm (angle per joint level 1.0). . *B0';; /1 FLENDER STANDARD COUPLINGS | INTRODUCTION 4 4 5 5 6 6 7 7 8 8 9 9 1 1 1 1 1 1 1 1 Balancing Balance quality levels The so-called quality level to DIN ISO 2 indicates range of permitted residual imbalance from zero up to an upper limit. Applications can be grouped on the basis of similarity analysis. For many applications coupling balance quality of 1 is sufficient. On drives susceptible to vibration the balance quality should be 6.3. Only in special cases is better balance quality required.Balancing standard in accordance with DIN ISO 2-3Besides the required balance quality, it is necessary to set standards which define how the mass of the parallel key is to be taken into consideration when balancing. In the past, motor rotors have frequently been balanced in accordance with the full parallel key standard. The "appropriate" balance condition of the coupling hub was described as "balancing with open keyway" or "balancing after key eating". Today it is usual for the motor rotor, as well as the gear unit and driven machine shaft, to be balanced in accordance with the half parallel key standard. Full parallel key standard The parallel key is inserted in the shaft keyway, then balancing is carried out. The coupling hub must be balanced without parallel key after keyseating. Marking of shaft and hub with "" (for "full"). Half parallel key standard The balancing standard normally applied today. Before balancing, half parallel key is inserted in the shaft and another in the coupling hub. Alternatively, balancing can be carried out before cutting the keyway. The balanced parts must be marked with an "". This marking can be dispensed with if it is absolutely clear which parallel key standard has been applied. No parallel key st