M Collective Cubic mean valueService factorsOpera B2SV-14-C Bevel-helical speed reducer B2

Flender/Flender Gear Units/Bevel-helical speed reducer B2

ll be easily accessible. Terminal blocks in separate groups shall be provided for SCADA/ Automati on, remote control panels, transformer arshalling boxes, local push button stations, etc. with proper truff arrangement for cable dressing. Terminal blocks shall be placed separately for internal looping and xternal looping. All CT and PT wires shall be irst brought to disconnecting type TBs. All metering CT-PT wires shall brought to test terminal bloc ks before connecting to circuits. Overall 2% spare terminals in each feeder shall be provided. he spare terminals shall be distributed appropriately during design stage. Gland plate for control cables shall be of adequate size to acc ommodate and to facilitate glanding of all the cont rol cables coming from exter nal equipment. 8.2 Power Terminations Suitable for accepting cable/bus trunking as specified/ required. Sufficient space and support arrangement inside each panel to ccommodate HT cable termination kits and sealing kits suitable for the size nd number of XLPE cables. Minimum height of termination point from gland plate shall be 9 0mm for 3kV switchboard and 6mm for 1kV and below switchboard. Rear extension is not permitted, unless specified otherwise. Dummy panels shall be provided adjacent to the feeders, where the required number of cable terminations cannot be accommodated in the cabling chamber of the feeder. 1 of 1 INDRADHANUSH GAS GRID LIMITED TECHNICAL SPECIFICATION FOR NATURAL GAS COMPRESSOR STATION FOR NORTH EAST GAS GRID PIPELINE PROJECT ______________________________________________________________________________________________ TS NO.: MEC//2UU/0/2/0 Electrical system Chapter-0.0 2, MECON Limited, All Right Reserved Pag 3 of 2 Where more than one cable have to be terminated per unit, the arrangement shall permit