Bevel-helical gearboxes B2 ze d l G l l kg kg Solid shaft without parallel ke B2FV-10-C

Flender/Flender Gear Units/Bevel-helical gearboxes B2

nt. 5 / 1BA 5 en 0/2.1 Speed transmitter An incremental speed transmitter may be mounted. Wiring and evaluation instrument should be provided by the customer. "" Fig. 4: Speedmonitoring device 1 Incremental transmitter 2 1pole brass plug 3 Output When operating and servicing the components, observe the operating instructions relating to the components.For technical data, refer to the data sheet and/or the list of equipment. detailed view of the gear unit can be obtained from the drawings in the gearunit documentation. 5 / 1BA 5 en 0/2. Fitting Observe the instructions in section 3, "Safety instructions"! 6.1 General information on fitting When transporting the gear unit observe the notes in section 4, "Transport and storage". Fitting work must be done with great care by authorised, trained and qualified personnel. The manufacturer cannot be held liable for damage caused by incorrect assembly and installation. During the planning phase sufficient space must be allowed around the gear unit for later care and maintenance work. Free convection through the surface of the housing must be ensured by suitable measures. If the gear unit is fitted with fan, there should be sufficient space for air intake. Adequate lifting equipment must be available before beginning the fitting work. During operation the unit must not be allowed to heat up through exposure to heat from external sources such as sunlight, and suitable measures must be taken to prevent this! Such measures may be: fitting sunshade roof, or fitting an additional cooling unit, or fitting the oil sump with temperaturemonitoring device with cutout function. If sunshade roof is fitted, heat must be prevented from building up! If temperaturemonitoring device is fitted, warning signal must be emitted when the maximum permitted oilsump temperature is reached. If the maximum permitted oilsump temperature is exceeded, the drive must be shut off.Such shutting off may cause the operator' system to stop! The oper